Installing System Components | 255
4
Replace the screws that secure the front-panel assemblies to the chassis.
See Figure 3-84.
5
Connect all the cables to the backplane. See Figure 3-81 for 3.5-inch
hard drives and Figure 3-82 for 2.5-inch hard drives.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
6
Connect front panel cables to the power distribution board. See Figure
3-96. You must route these cables properly on the chassis to prevent
them from being pinched or crimped.
7
Replace the screws that secure the hard-drive cage. See Figure 3-83.
8
Close the system, see “Closing the System” on page 219.
9
Replace the hard drives. See “Installing a Hard Drive into a Hard-Drive
Carrier” on page 138.
10
Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.