Dell PowerEdge 2450, Installation And Troubleshooting Manual

Page: 25 / 166

support.dell.com Messages and Codes 3-9
"
Improperly seated DIMMs or
faulty keyboard/mouse controller
chip (defective system board) Remove and reseat the DIMMs.
If the problem persists, replace
the DIMMs. If the problem still
persists, replace the system
board. See Chapter 11, “Getting
Help,” for instructions on obtain-
ing technical assistance.
"(+"
*1
"(+"
Microprocessor not supported by
system Install a correct version of the
microprocessor in the specified
microprocessor connector.
"(+"
(*
Microprocessor not supported by
BIOS Upgrade the BIOS. See
Chapter 4, "Using the System
Setup Program," in the
User's
Guide for instructions.
"#$
!)$#
#$
RAID DIMM not supported by
system Install a correct version of the
RAID DIMM.
")$#
RAID hardware key not supported
by system Install the RAID hardware key for
your specific system.
"
<F10> key was pressed during
POST, but no utility partition
exists on the boot hard-disk drive Create a utility partition on the
boot hard-disk drive. See “Using
the
Dell OpenManage Server
Assistant CD” in your User’s
Guide.
9#
,!)$#($
!)$#!
#,
+:
!!;
!
Type of controller has changed
since previous system boot Back up information on the drives
before changing the type of con-
troller used with the hard-disk
drives.
9
9
Faulty diskette or hard-disk drive Replace the diskette or hard-disk
drive.
NOTE: For the full name of an abbreviation or acronym used in this table, see “Abbreviations and Acronyms."