4. Disassembly and Assembly Procedures
S16
Take 1pcs USB board, 1pcs LVDS cable, 1pcs
conductive foam. Connect the LVDS cable to the
connector of the USB board, then paste 1pcs
conductive foam on the back of the USB board, and
then locate the USB board into the correct
position of the middle bezel. Use a Philips-head
screwdriver to tighten 1pcs screw for locking the
USB unit with the middle bezel, then connect the
cable with assemble unit.
(No.1 screw size=M3x6, Torque=4
±
0.5
kgfxcm)
Move the assembled rear cover close to the
panel unit, then connect the key cable to the
connector of interface board. Put down the rear
cover and push the rear cover on the positions
marked as the picture below shown for
mechanisms engagement.
S18
Paste 1pcs aluminum foil to cover the two LVDS
connectors, then use a Philips-head screwdriver to
tighten 4pcs screws for locking the middle bezel with
front bezel.
(No.1~4 screw size=M2x3.5, Torque=2.5
±
0.5
kgfxcm)
S14
Paste 1pcs conductive tape to cover the panel lamp
connectors as the picture below shown.
S15
1
Take 1pcs joystick key and 1pcs OSD board,
assemble the joystick key with the OSD board.
Locate the board to the correct position of the rear
cover, then use a Philips-head screwdriver to tighten
2pcs screws for locking the board with rear cover.
Tear off the tape papers on the back of the cable,
and then fix the key cable with tapes.
(No.1 screw size=M2x2.4, Torque=0.9
±
0.1
kgfxcm)
S17
1
2
1
4
2
3
