4. Disassembly and Assembly Procedures
S11
S10
S12
S13
3
14
2
1
Take 1pcs LED board and 1pcs middle bezel, then
put the middle bezel into a fixture jip to fix the middle
bezel. Locate the LED board to the correct positions
of the middle bezel.
Philips-head screwdriver
to tighten
Stick a big piece of mylar tape to cover
the LED board.
Use a
1pcs screw for locking the LED board with
middle bezel.
(No.1 screw size=M2x2.4, Torque=0.8
~
1
kgfxcm)
Take 1pcs panel lamp cable to connect the circuit
board with the connectors of the panel module.
S8
S9
Take 1pcs front bezel, then lift up the panel with
bracket and assemble the front bezel with the panel
module.
2
Move the middle bezel with the LED board close to
the panel unit, then assemble the middle bezel with
the front bezel and panel module.
Tear off the papers of the tapes on the back of the
LED cable, and then fix the LED cable on the panel
with 2pcs tapes, then connect the LED cable with
the connector of the board.
Paste 1pcs aluminum foil to fix the bracket, LED
cable and LVDS cable on the specific position as the
picture below shown. Use a Philips-head screwdriver
to tighten 14pcs screws for locking the middle bezel
with the panel module.
(No.1~14 screw size=M3x5, Torque=5
±
0.5
kgfxcm)
4
5
6
7
8
9
10
11
12
13
