Message
Description
the F1 key to
continue, F2 to run
the setup utility.
No boot device
available
No bootable partition on the hard drive, a cable or connector is loose, or no bootable device
exists.
•
If the hard drive is your boot device, ensure that the cables are connected and that the
drive is installed properly and partitioned as a boot device.
•
Enter system setup and ensure that the boot sequence information is correct.
No timer tick interrupt A chip on the system board might be malfunctioning.
USB over current
error
Disconnect the USB device. The USB device needs more power for it to function properly. Use
an external power source to connect the USB device, or if the device has two USB cables,
connect both of them.
CAUTION - Hard
Drive SELF
MONITORING
SYSTEM has reported
that a parameter has
exceeded its normal
operating range. Dell
recommends that you
back up your data
regularly. A
parameter out of
range may or may not
indicate a potential
hard drive problem
S.M.A.R.T error or possible hard disk drive failure. Contact Dell and report the issue to a
support technician.
71
