Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive connector.
2. Insert the solid-state drive at a 45-degree angle into the slot on the system board.
3. Replace the screw (M2x3.5) to secure the M.2 2280 solid-state drive to the system board.
NOTE:
Repeat the above procedure for installing the other solid-state drive.
Next steps
1. Install the
.
2. Follow the procedure in
after working inside your computer
.
Memory modules
Removing the memory modules
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
About this task
The following images indicate the location of the memory modules and provide a visual representation of the removal procedure.
Steps
1. Pull the securing clips from both side of the memory module until the memory module pops up.
2. Slide and remove the memory module from the memory-module slot.
Disassembly and reassembly
37
Summary of Contents for OptiPlex 7080 Tower
