c Lift the display assembly away from the computer [2].
Installing the display assembly
1
Place the base of the computer on a flat surface.
2
Install the display assembly by aligning it with the display hinge screw holders.
3
Replace the M2.5 x 4.0 screws to secure the display assembly.
4
Close the display assembly and flip the computer.
5
Connect the cables:
a G-sensor and eDP cable
b Place the eDP bracket on the eDP cable and replace the M 2 x 1.7L screw on the bracket.
c IR camera and touch screen cables
6
Route the antenna cables through the routing clips
7
Affix the tapes to secure the antenna cables to the system board.
8
Install the:
a
b
c
d
e
9
Follow the procedure in
After working inside your computer
.
System Board
26
Removing and installing components
Summary of Contents for Latitude 7389
