System board
Removing system board
1
Follow the procedure in
Before working inside your computer
.
1
If your computer is shipped with a WWAN card, then the removal of a blank SIM card tray is a requirement.
2
Remove the:
a
b
c
d
e
f
g
h
i
2
To identify the screws, see
3
To disconnect the eDP cable:
NOTE:
If your system is shipped with an IR camera, then the IR cable must be disconnected. The IR cable is located
beneath the eDP cable connector
a Un route the WLAN and WWAN cables from the routing channels [1].
b Remove the two (M2.0 x 3.0) screws that secures the eDP cable [2].
c Remove the eDP cable bracket [3].
d Disconnect the eDP cable from the system board [4].
e Lift the tape that secures the eDP cable to the system board [5].
Removing and installing components
33
