Dell IP4700, Installation And Service Manual

Page: 43 / 126

2
Installing an IP4700 in a Cabinet
2-7
Installing an IP4700
Installing an IP4700 in a Cabinet
The cabinet in which the IP4700 is installed must have a full earth
ground to provide reliable grounding. Also, the cabinet should have
its own switchable, dual power distribution units, one on each side.
WARNING
The rackmount IP4700 is heavy and should be installed into a rack
by two people. To avoid personal injury and/or damage to the
equipment, do not attempt to lift and install the IP4700 into a rack
without help from another person.
WARNING
Das Rackmount-IP4700 ist schwer und sollte nur von zwei Personen
in einem Gehäuse installiert werden. Zur Vermeidung von
körperlichen Verletzungen und/oder der Beschädigung des Gerätes,
bitte die IP4700 nicht ohne die Hilfe einer zweiten Person anheben
und einbauen.
We recommend that you use cabinet anti-tip devices, especially if you
are installing or removing an IP4700 in the upper half of the cabinet
and the lower half is empty.
To install the cabinet itself you will need to refer to the cabinet
installation manual that shipped with the cabinet.
You install each IP4700 on two L-shaped mounting rails connected to
the cabinet’s vertical channels. Installing the mounting rails in the
cabinet is explained in the rails installation document that shipped
with the rails.
See Figure 2-5 for a sample configuration. Note that this is just an
example of how the system might be configured; your configuration
may differ.