Replacing the power and
volume-buttons board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance
.
Procedure
1
Align the screw hole on the power and volume-buttons board with the
screw hole on the palm rest and keyboard assembly.
2
Replace the screw that secures the power and volume-buttons board to
the palm rest and keyboard assembly.
3
Route the power and volume-buttons board cable through the routing
guides on the palm rest and keyboard assembly and the speaker.
4
Connect the power and volume-buttons board cable to the I/O board.
5
Connect the coin-cell battery cable to the I/O board.
Post-requisites
1
.
2
.
68
Summary of Contents for Inspiron 13 5000 Series 2-in-1
