rSPI card (optional)
rSPI (restore Serial Peripheral Interface) is a SPI flash device to store information about the system Service Tag, system configuration, or
iDRAC license.
Removing the optional rSPI card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
Steps
1. Remove the two screws securing the rSPI card to the system board.
CAUTION:
To prevent damage to the rSPI card, you must hold the card only by its edges.
2. Lift the card up and away from the system.
Figure 29. Removing the optional rSPI card
1. screw (2)
2. rSPI card
3. standoff (2)
4. connector
Next steps
1. Install the rSPI card.
2. Follow the procedure listed in the After working inside your system section.
Related References
Installing and removing server module components
79
