NOTE:
Slot 1 does not function when Pentium processor is installed.
NOTE:
The expansion cards are not hot swappable.
NOTE:
For a system with 8 TB (or more) drive capacity, PERC is required for thermal control.
The following table describes the installation order for installing expansion cards to ensure proper cooling and mechanical fit:
The expansion cards with the highest priority must be installed first by using the slot priority indicated.
Table 16. Expansion card installation order
Card type
Slot priority
Maximum allowed
Maximum PCIe width
H755
2
1
x 8
HBA355i
2,1
1
x 8
HBA355e
2,1
2
x 8
H345
2
1
x 8
Broadcom (NIC: 1Gb)
2, 1, 4
3
x 4
Intel (NIC: 1Gb)
2, 1, 4
3
x 4
Dell BOSS S1 Module
2, 1, 4
3
x 8
Removing a PCIe expansion card
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3. Disconnect any cables connected to the expansion card.
NOTE:
The procedure to remove the storage controller card and BOSS S1 is similar to removing the PCIe expansion card.
Steps
1. Press the blue retention latch and push down the latch to open it.
2. Hold the expansion card by the edges and pull the card to disengage from the system.
Figure 37. Removing a PCIe expansion card
48
Installing and removing system components
