Dell Embedded Box PC5000, Service Manual

Page: 77 / 136

Removing the CANbus cable
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in
Before working inside your Embedded Box PC . After working inside your
Embedded Box PC, follow the steps in After working inside your Embedded
Box PC . For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance .
Prerequisites
1 Follow step 1 to step 6 in “ Removing the back cover ”.
2 Remove the PCI/PCIe card (if installed).
Procedure
1 Disconnect the CANbus cable from the connector on the CANbus card.
2 Remove the CANbus cable from the routing guides on the chassis.
3 Slide the cable out from under the heat sink pipe.
4 Remove the hexagonal screws that secure the CANbus port to the top cover.
77