Replacing the system board
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in
Before working inside your Embedded Box PC
. After working inside your
Embedded Box PC, follow the steps in
After working inside your Embedded
. For more safety best practices, see the Regulatory Compliance
home page at
www.dell.com/regulatory_compliance
NOTE: Your Embedded Box PC’s Service Tag is stored in the system board.
You must enter the Service Tag in the BIOS setup program after you replace
the system board.
NOTE: Replacing the system board removes any changes you have made to
the BIOS using the BIOS setup program. You must make the appropriate
changes again after you replace the system board.
Procedure
1
Place the system board on the chassis.
2
Align the screw holes on the system board with the screw holes in the chassis.
3
Replace the screws that secure the system board to the chassis.
4
Connect the serial-port cable, SATA data-cable, and SATA power-cable to the
connectors on the system board.
Post-requisites
1
Replace the
2
Follow step 2 to step 6 in
3
Replace the
4
Replace the
5
Replace the
6
Replace the
.
7
Replace the
.
8
Replace the
.
9
Replace the
or
123
Summary of Contents for Embedded Box PC5000
Page 122: ...3 Lift the system board off the chassis 1 chassis 2 system board 122 ...
Page 131: ...3 Remove the Dell logo board from the front chassis 1 Dell logo board 2 front chassis 131 ...
Page 133: ...15 Follow step 2 to step 8 in Replacing the back cover 133 ...
Page 136: ...CANbus The CANBus daughter card is an optional accessory for Embedded Box PC 136 ...
