Dell Embedded Box PC 5000, Service Manual

Page: 84 / 115

Removing the intrusion switch
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
Before working inside your Embedded Box PC .
After working inside your Embedded Box PC, follow the steps in After
working inside your Embedded Box PC . For more safety best practices,
see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance .
Prerequisites
1 Follow step 1 to step 6 in “ Removing the back cover ”.
2 Remove the PCI/PCIe card (if installed).
Procedure
1 Disconnect the intrusion-switch cable from intrusion-switch connector
on the system board.
2 Remove the intrusion-switch cable from the routing guides on the
chassis.
3 Slide the cable out from under the heat sink pipe.
4 Remove the screw that secures the intrusion switch to the chassis.
84