Dell Embedded Box PC 5000, Service Manual

Page: 10 / 115

Before working inside your
Embedded Box PC
NOTE: The images in this document may differ from your Embedded
Box PC depending on the configuration you ordered.
Before you begin
1 Save and close all open files and exit all open applications.
2 Shut down the Embedded Box PC.
The shut-down instruction varies depending on the operating system
installed on the Embedded Box PC.
NOTE: For more information, see the documentation of your
operating system for shut-down instructions.
3 Disconnect the Embedded Box PC and all attached devices from their
electrical outlets.
4 Disconnect all cables such as network cables from the Embedded Box
PC.
5 Disconnect all attached devices and peripherals, such as keyboard,
mouse, and monitor, from the Embedded Box PC.
6 After the Embedded Box PC is unplugged, press and hold the power
button for 5 seconds to ground the system board.
Safety instructions
Use the following safety guidelines to protect your Embedded Box PC from
potential damage and ensure your personal safety.
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
Before working inside your Embedded Box PC .
After working inside your Embedded Box PC, follow the steps in After
working inside your Embedded Box PC . For more safety best practices,
see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance .
10