Dell E70S, Installation And Service Manual

Page: 85 / 238

Figure 84. Removing the 4 x 2.5-inch rear drive module
Next steps
1. Replace the 4 x 2.5-inch rear drive module .
Installing the 4 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions .
2. Follow the procedure listed in Before working inside your system .
3. If required, remove the air shroud .
4. Remove the drives .
5. If installed, remove the BOSS S2 module .
6. Disconnect the cables from the rear drive module.
NOTE: Refer cable routing topic for more information.
Steps
1. Align and lower the rear drive module with the guide on the system board.
2. Using a Phillips #2 screwdriver, tighten the captive screws that secures the rear drive module into the system.
Installing and removing system components 85