Removing the hard-drive backplane
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
.
2.
Follow the procedure listed in
Before working inside your system
CAUTION: To prevent damage to the drives and backplane, remove the hard drives from the
system before removing the backplane.
CAUTION: Note the slot number of each hard drive and temporarily label the slots before
removing the hard drives so that you can replace them in the same locations.
3.
Remove all hard drives.
Steps
1.
Disconnect the SAS, power, and signal cables from the hard-drive backplane.
NOTE: For the x8 backplane, press the SAS connector and push the connector toward the top
of the system to release the SAS cable from the backplane.
2.
Pull the release pin and lift the backplane out of the system.
Figure 28. Removing and installing an x16 hard-drive backplane
1.
x16 hard-drive backplane
2. release pin
3. power connector
4. power cable
77
