Dell E1200i ExaScale, Installation Manual

Page: 75 / 96

System Boot |
75
6
interface management
port config 100m
interface management
port config 10m
interface management
port config auto-
negotiate
interface management
port config no auto-
negotiate
interface management
port config full-duplex
interface management
port config half-duplex
interface management
port config show
• (OPTIONAL) Use these commands to set the speed and duplex settings for the
Management interface.The default setting is full-duplex and auto-negotiation.
• Use the
interface management port config show
command to view
the Management interface’s physical settings.
7
show interface
management ethernet
interface management
ethernet ip address
ip-
address ip-address-mask
• Use the
show interface management ethernet
command to display
the IP address and network mask of the management Ethernet port.
• If the
show
command output does not display configured IP address
information, use the
interface management ethernet ip address ip-
address ip-address-mask
command to set the IP address of the
Management Ethernet port for network (ftp/tftp) operating system boot.
8
show default-gateway
default-gateway
ip-
address
(Optional) Use the
show default-gateway
command to view gateway
information.
If your server is on the same subnet, you do not need to configure a gateway
parameter.
If your server is not on the same subnet, use the
default-gateway ip-address
command to set the gateway IP address.
Step Command Task
(continued)
BOOT_USER # show interface management ethernet
No IP address set for interface management ethernet 0/0!
BOOT_USER # interface management ethernet ip address 1.2.3.4 255.255.0.0
Management ethernet 0/0 IP address: 1.2.3.4 255.255.0.0
BOOT_USER # show interface management ethernet