Dell E1200i ExaScale, Installation Manual

Page: 15 / 96

Site Preparation |
15
3
Site Preparation
This chapter describes factors to consider before installing your E1200 system. The following topics are
discussed:
• Site Selection Criteria
• Rack Mounting
• Cabinet Placement
• Power
• Fans and Airflow
• Storing Components
For complete E1200 System Specifications, refer to Chapter C, System Specifications .
Site Selection Criteria
Before you begin the installation process, make sure that the area where you intend to install your E1200
meets the following safety requirements.
Select a site:
• In a restricted access area.
• In a dry, clean, well-ventilated and temperature-controlled room, away from nearby heat sources such as
hot air vents or direct sunlight.
• Away from sources of severe electromagnetic noise.
• Near an adequate power source. Connect the E1200 to the appropriate branch circuit protection as
defined by local electrical codes.
• Means of power disconnect must be located near the equipment.
• Position in a rack with adequate space in the front and rear, and sides of the unit for proper ventilation,
access to cables, and maintenance access. Allow
at least
18 inches in the front and 20 inches in the rear
of the rack for ventilation. If placing the chassis in a cabinet, ensure that there is enough clearance
between the closed cabinet door and the cables in the cable management system on the chassis.
• Ensure that the ambient temperature around the unit (which may be higher than the room temperature) is
within the limit specified for the unit.
• Ensure that there is sufficient airflow around the unit and that the electrical circuits are not overloaded.
Consider the nameplate rating of all the connected equipment, and ensure that there is over current
protection.