Installing the front system fan assembly
1. Hold the system fan by the sides with the cable end facing the bottom of the chassis.
2. Replace the two screws securing the system fan assembly in front of the system.
3. Replace the two screws securing the system fan assembly in the system.
4. Connect the four system fan cables to the system board.
5. Route back the internal chassis speaker cable through the clip on the system fan assembly, and connect the internal chassis speaker
to the connector.
6. Replace the intrusion switch module to the slot on the fan assembly and insert the screw to secure it with the system fan assembly.
7. Install the following components:
a)
b)
c)
d)
8. Follow the procedure in
After working inside your computer
.
Internal chassis speaker
Removing the internal chassis speaker
1. Follow the procedure in
Before working inside your computer
.
2. Remove the following:
a)
Removing and installing components
31
Summary of Contents for D04X
