ASSEMBLY INSTRUCTIONS
GC10/12
Heavy Duty Workstation
Model: CWB1830S (with lower half shelf)
Part No: 7637855
Page 1: ...ASSEMBLY INSTRUCTIONS GC10 12 Heavy Duty Workstation Model CWB1830S with lower half shelf Part No 7637855 ...
Page 2: ...en enter the slots fully using just firm hand pressure but if they are too tight you may require a rubber mallet or hammer to assist If so always use a cloth to protect the product paint finish Post A Post B Post C Mid End Beam Upper End Beam Shelf Support Beam Lower End Beam Plastic Foot Centre Support 1 x Shelf Support Beam I 2 x Mid End Beams J 2 x Lower End Beams with holes K x Upper End Beams...
Page 3: ...me assembly as shown in Fig 2 Note that the lower shelf should be less than half distance from floor to large shelf for optimum stability 4 Repeat this again for the other end assembly making sure that the corresponding lower end support is at the same height Note that the edge with the wider flange should be installed uppermost to touch the shelf and that the face with open edges should face the ...
Page 4: ...your statutory rights Parts Service 020 8988 7400 E mail Parts clarkeinternational com or Service clarkeinternational com FIG 5 Shelf Support Beam Plastic Foot Post FIG 6 FIG 7 Upper End Beam Plastic Post Cap I A D L E 7 Slot the shelf support beam between the long beams to carry the large board as in Fig 5 I G P 8 Fix the shelf clips to the centre support and place the medium board on the half sh...
