4. Install the
5. Flip the system back with the system cover facing up where the release latch is available.
6. Remove the following components :
a)
b)
c)
7. To remove the intrusion switch module:
a) Pull the bottom intrusion switch cable up toward the chassis [1].
b) Press the tab to disconnect the intrusion switch cable from the system board [2].
c) Unroute the intrusion switch cables from the clip on the chassis [3].
d) Remove the screw on the intrusion module [4].
e) Lift the intrusion module from the front system fan assembly [5].
26
Removing and installing components
Summary of Contents for D04X
