Dell BigIron RX Series, Configuration Manual

Page: 863 / 1458

BigIron RX Series Configuration Guide 787
53-1002253-01
Modifying redistribution parameters
26
The static parameter indicates that you are redistributing static routes into BGP.
Redistributing connected routes
To configure BGP4 to redistribute directly connected routes, enter the following command.
BigIron RX(config-bgp)# redistribute connected
Syntax: redistribute connected [metric <num> ] [route-map <map-name> ]
The connected parameter indicates that you are redistributing routes to directly attached devices
into BGP4.
The metric <num> parameter changes the metric. You can specify a value from 0 – 4294967295.
The default
is not assigned.
The route-map <map-name> parameter specifies a route map to be consulted before adding the
RIP route to the BGP4 route table.
NOTE
The route map you specify must already be configured on the router. Refer to “Defining route maps”
on page 801 for information about defining route maps.
Redistributing RIP routes
To configure BGP4 to redistribute RIP routes and add a metric of 10 to the redistributed routes,
enter the following command.
BigIron RX(config-bgp)# redistribute rip metric 10
Syntax: redistribute rip [metric <num> ] [route-map <map-name> ]
The rip parameter indicates that you are redistributing RIP routes into BGP4.
The metric <num> parameter changes the metric. You can specify a value from 0 – 4294967295.
The default
is not assigned.
The route-map <map-name> parameter specifies a route map to be consulted before adding the
RIP route to the BGP4 route table.
NOTE
The route map you specify must already be configured on the router. Refer to “Defining route maps”
on page 801 for information about defining route maps.
Redistributing OSPF external routes
To configure the device to redistribute OSPF external type 1 routes, enter the following command.
BigIron RX(config-bgp)# redistribute ospf match external1
Syntax: redistribute ospf [match internal | external1 | external2] [metric <num> ] [route-map
<map-name> ]
The ospf parameter indicates that you are redistributing OSPF routes into BGP4.