Dell 610D, Service Manual

Page: 16 / 47

8. Remove the display panel from the top cover.
9. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
10. Press in both sides of the top display cable connector, and pull the display cable connector away from the top flex-cable connector.
Installing the Display Panel
1. Connect the top display cable connector to the top flex-cable connector.
2. Connect the bottom flex-cable connector to the inverter connector.
3. Replace the display panel inside the top cover.
4. Tighten the four M2 x 3-mm screws (two on each side) around the display panel.
5. Replace the display bezel (see " Installing the Display Bezel ").
Display Latch
Removing the Display Latch
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the center control cover (see " Removing the Center Control Cover ").
3. Remove the keyboard (see " Removing the Keyboard ").
4. Remove the display assembly (see " Removing the Display Assembly ").
5. Remove the display bezel (see " Removing the Display Bezel ").
6. Remove the M2.5 x 5-mm screw that secures the display latch to the top cover.
1 display panel
2 top cover
3 M2 x 3-mm screws (4)
1 top flex-cable connector
2 top display-cable connector
3 pull-tab on bottom flex-cable connector
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.