Replacing the Media Card Reader
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Replacing the Computer Cover
).
3.
Remove the front panel (see
Replacing the Front Panel
).
4.
Remove any expansion cards (see
Replacing a PCI/PCI Express Card
).
5.
Disconnect the cable that is connected to the mediacard reader from the system board (F_USB4).
6.
Remove the screw that secures the Media Card Reader to the chassis.
7.
Carefully remove the existing Media Card Reader from the computer.
8.
To install a new Media Card Reader, align and slide the Media Card Reader clamp into the Media Card Reader clamp slot.
9.
Replace and tighten the screw that secures the Media Card Reader to the chassis.
10.
Reconnect the cables to the system board.
NOTICE:
To comply with FCC regulations, it is recommended that you replace the drive panel insert whenever the FlexDock is removed from the
computer.
1
back of the computer
2
drive panel insert (optional)
NOTICE:
Carefully note the routing of each cable before you disconnect it, so that you are sure to re-route cables correctly. An incorrectly routed or a
disconnected cable could lead to computer problems.
1
screw
2
Media Card Reader
3
Media Card Reader clamp
Summary of Contents for 540 - USB Photo Printer 540
Page 11: ......
Page 25: ...Back to Contents Page ...
