110
Serial/Modem Channel Configuration Sub-task
The serial/modem channel configuration subtask, shown in Figure 37, allows you to modify
settings that relate to the serial/modem channel, set up dial strings to which alerts are sent, and
specify the settings related to sending alerts to those destinations.
This subtask includes a screen that allows you to configure the settings for the terminal mode of
operation of the serial/modem channel.
Figure 37. Serial / Modem Channel Configuration
After completing this screen, click Next to move to the next screen to continue this subtask. The
screen that is displayed when the Next button is clicked depends on which connection mode is
chosen:
•
If modem mode is selected, the next screen displayed allows setup of modem parameters.
•
If direct connect is selected, since there are no configuration parameters to set, the next screen
displayed is the Destination Dial Strings screen.
Default Serial/Modem Configuration Settings Set By the SMU
The SMU sets some serial/modem configuration settings automatically. This information is listed
below, but is not displayed on the screen. The list of these settings is given below. Before this
information is set by the SMU, you must click through the remaining Serial/Modem Channel
Configuration subtask screens to click the Save button on the last screen.
•
Authentication type enables are enabled. These bits define what types of authentication are
enabled to authenticate messages sent to the BMC by users of different privilege levels. The
SMU enables authentication of type straight password, MD2, MD5, and none.
•
Basic mode is enabled, allowing basic serial communications to take place over the
serial/modem channel.
•
Session inactivity timeout is set to one minute.
Summary of Contents for 3250
Page 1: ...Dell TM PowerEdge TM 3250 SR870BH2 Systems Product Guide Model Code SVS ...
Page 22: ...22 ...
Page 240: ......
