2
Follow the procedure listed in
Before working inside your system
.
3
4
Remove the internal PERC riser.
Steps
1
Disconnect the control panel cable from the system board connector.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
2
Using a Phillips #1 screwdriver, remove the screws that secure the cable cover.
Figure 99. Removing the cable cover
3
Using a Phillips #1 screwdriver, remove the screws that connect the control panel to the system.
Figure 100. Removing left control panel
4
Holding by the sides, remove the left control panel assembly away from the system.
Next step
Install the left control panel.
Related links
Installing the left control panel
Installing and removing system components
137