Next steps
1
Install the processor and heat sink module
.
2
Follow the procedure listed in
After working inside your enclosure
.
Removing the non-fabric processor from the processor and
heat sink module
Prerequisites
NOTE:
Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink. This
procedure is not required when replacing a system board.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your enclosure
3
4
Remove the processor and heat sink module
Steps
1
Place the heat sink with the processor side facing up.
2
Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3
Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Figure 37. Loosening the processor bracket
90
Installing and removing enclosure components
Summary of Contents for PowerEdge C6420
