Figure 27. Installing the support bracket
Next steps
1
Install the sled into the enclosure
2
Follow the procedure listed in
After working inside your enclosure
.
Linking board and PCIe cable
Removing the linking board and PCIe cables
Prerequisites
NOTE:
Observe the routing of the cable as you remove it from the sled. Route the cable properly when you replace it to prevent
the cable from being pinched or crimped.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your enclosure
3
.
4
.
Steps
1
Press the release clip on the PCIe_A cable connector to disconnect the cable. See the
for more information.
2
Press the release clip on the PCIe_B cable connector to disconnect the cable. See the
for more information.
3
If connected, disconnect the SATA cable from the x16 M.2 riser.
4
Using the Phillips #1 screwdriver, loosen the captive screws on the linking board and lift the board up along with the cables.
80
Installing and removing enclosure components
Summary of Contents for PowerEdge C6420
