Dell EMC PowerEdge C4140, Installation And Service Manual, Page: 93 / 133

Figure 49. Installing the cable guides, NDC guide, PCIe guide, and PCH shroud base
Next steps
1 Replacing the Trusted Platform Module
NOTE: The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module is provided for all system board replacements, where a TPM plug-in module was installed.
2 Replace the following:
a
Replacing the optional internal USB memory key
b Installing a processor and heat sink module
c Processors blanks (if applicable)
d Installing a memory module
e Installing the expansion card risers
f Installing PCH air shroud.
g Installing the air shroud
3 Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4 Follow the procedure listed in After working inside your system .
5 Ensure that you:
a
Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy restore section.
b If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see the
Restoring the Service Tag by using the Easy Restore feature section.
c Update the BIOS and iDRAC versions.
d Re-enable the Trusted Platform Module (TPM). For more information, see the Replacing the Trusted Platform Module section.
6 Import your new or existing iDRAC Enterprise license.
For more information, see iDRAC User's Guide, at
Dell.com/idracmanuals .
Installing and removing system components 93