Figure 57. Installing the low profile right riser
Next steps
1. If required, re-connect the cables to the expansion card.
2.
.
3. Follow the procedure listed in
After working inside your system
.
4. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in the
Before working inside your system
3.
.
4. If applicable, disconnect the cables from the expansion card.
NOTE:
The procedure to remove the T4 GPU card and the expansion card is the same.
Steps
1. Pull and lift up the expansion card retention latch lock to open.
2. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
66
Installing and removing system components
