Delitek Waste Compactors – user -/service manual-rev 1.2
DT-200i “Green Ship” Waste Compactor – standard versions 2
IMPORTANT SAFETY INSTRUCTIONS:
Please follow these precautions when using this product:
1. Read carefully through and follow the instructions given in this manual
2. Pay attention to all warnings.
3. Installation must be done in accordance to this manual.
4. Protect and avoid the power cable from being walked on, driven over etc. Do not
bend the power cable close to the connections.
5. Use only original spare parts approved and recommended by Delitek AS.
6. Qualified personnel only must perform repairs and services.
7.
WARNING:
Do not expose the el-locker or el-engine with direct spurt of
water.
8. The compactor must be placed in an environment that has an operating temperature
between minimums –25 degrees Celsius to maximum 60 degrees Celsius.
9.
WARNING:
The compactor is normally transported standing upright vertically, on a
wooden transport frame (ISPM#15). The transport frame is lifted/relocated by using a
forklift or a jack-trolley. Note: lifting is done by the indicated lifting pockets. If the
waste compactor needs to be lifted after the compactor is unpacked, this must be
done with certified lifting straps around compactor house.
10.
WARNING:
Do not lift the compactor by using holes on the compactor house or other
parts of the compactor that is not suited for a lifting operation.
11.
WARNING:
The
safety distance for the compactor-operator should be at least 1
meter. No persons must be standing in front of the compactor opening during the
compaction cycle.
12. The compactor is designed to compress mixed consumer waste such as paper,
various plastic waste, paperboard, tin-boxes, packaging, food waste etc. If several
containers are used, the waste should be segregated by source according to IMO/
MARPOL 73/78 annex V. By doing this you will also obtain a higher degree of
compaction.
13.
WARNING:
Waste that is considered as ”hazardous” or “special category waste”
must never be deployed or compressed in the container. Because of fire and
explosion hazard, never deploy hot ashes or any type of gas domes into the waste
compactor.
14. Ensure that the control panel and the area around the compactor have sufficient
lighting according to working environment law at site.
15. Qualified personnel must perform a function test of security switches/emergency
switch at regular intervals. See chapter 6 for service/maintenance of the compactor. If
a malfunction appears when the system is running and pressurized, contact Delitek
AS to get a description on how to get the pressure balanced.
WARNING!
The standard versions of the DT-200i must be installed in an unclassified
zone onboard ships or offshore rigs. Only Ex-proof versions of the Delitek
compactors can be used in hazardous areas.
