Delitek Waste Compactors – user -/service manual-rev 1.2
DT-200i “Green Ship” Waste Compactor – standard versions 16
3.3 Deploying full plastic bags
When the plastic bag is full and ready for deployment, you
may roll the whole container from the compactor unit and
directly to the place of deployment.
Remember that you will have to tilt the container in order to
roll the container.
Remove the strap around the bag. Open the door in front of
the container and remove the bag easily, without any need for
lifting over the top of the container (see fig. 17).
In order to seal the plastic bag before deployment, we
recommend using a standard plastic strip of 20~30 cm (see
fig.18). This is an easy and very fast method for sealing the
bag.
You can of course also use other methods such as standard
brown packaging tape or just tie it with rope, whatever is most
convenient.
NOTE:
For collection and easy deployment of bags to
shore, it is possible to collect the smaller plastic bags
onboard in larger “Big Bags”. This bags can later be
removed from the vessel by the ships crane. They are
are equipped with four lifting loops on top (and one in the
bottom for emptying purpose) and has an SWL 1000KG
(see fig. 19). “Big bags” can be ordered from
Delitek AS. See chapter 8.0 for ordering information.
WARNING:
International weight limits sets a limit of 25 kg for manual lifting. Normally the output from the
DT-200 will not exceed 25 kg, but be aware of this restriction when lifting full bags.
Figure 17. Open door container
Figure 19. “Big bags”
Figure 18. Sealing the bag
