Screw C
Screw D
Screw E
To adjust the anti-tipper position
; first; loosen screws C & E. Then remove
screw D; be careful not to lose the washers. Rotate the anti-tipper assembly around
the axle to position 1 - 5 to suit the axle setting. Line up the appropriate hole or slot
in the adjuster plates and replace screw D; there should be spring washers between
the plates and the tube and plain washers under the screw head and the nut (see
diagram below). The end of the anti-tipper tube should be approximately 22mm from
the floor when deployed on a level surface.
Pg
.17
Spacing
Plates
Flat
Washers
FIG.21
FIG. 20
