![background image](http://html1.mh-extra.com/html/delfield/versa-drawer-18650vdl/versa-drawer-18650vdl_service-manual_2466495007.webp)
7
Versa Drawer Refrigeration Units
COMPONENT REMOVAL AND REPLACEMENT
Lo Profile and 2-Drawer refrigeration units use one
compressor, one accumulator, one receiver and four
solenoids. In addition, one evaporator is used for each
drawer along with support components. The 4-Drawer
refrigeration unit uses two complete 2-Drawer units.
Component removal and replacement is similar for
both types.
Perform the following procedures to remove and replace
parts. To eliminate mistakes when ordering parts, always
provide the following information:
• Model Number
• Serial Number
COVERS AND PANELS
Front Louvered Panel
NOTE:
Front louvered panel removal is similar
for all models.
1. Lift up on louver from bottom and pull away from
unit (Figure 1).
2. Reverse the above step to install the front
louvered panel.
Front louvered panel
Figure 1. Front Louvered Panel
Louvered Access End Panel
NOTE:
Louvered access end panel removal
is similar for all models.
1. While supporting the louvered access end panel,
remove mounting screws.
2. Lift louvered access end panel out and up to remove.
3. Reverse the above steps to install the louvered
access end panel.
Rear Panel
1. While supporting the rear panel, remove 11 screws.
2. Remove the rear panel from the unit.
3. Reverse the above steps to install the rear panel.
DRAWER ASSEMBLY
Drawer Removal
1. Empty the drawer.
2. Pull and lift the drawer to remove it from the unit
(Figure 2).
Drawer
Figure 2. Drawer Removal
Drawer Gasket
The drawer gasket is installed on the inner side of the
drawer front and fitted into a slot (Figure 3).
1. Remove the drawer gasket by carefully pulling the
drawer gasket out of the groove.
2. Reverse the above step to install the drawer gasket.
Drawer Front Assembly
1. Remove the drawer from the refrigeration unit (Figure 3).
2. Place the drawer on a solid surface with the drawer
front assembly down.
3. Remove six screws securing the drawer front
assembly to the drawer.
4. Reverse the above steps to install the drawer front
assembly.