Concepts Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
6
Line Up Installation
1. Identify where the equipment will be installed.
•
Units represented in this manual are for indoor use only.
•
Be sure the location chosen has a floor strong enough to support
the total weight and contents. Call the factory if necessary to
determine total weight. Reinforce the floor as necessary to
provide for maximum loading.
•
Do not install heated units near combustible objects or surfaces
affected by heat or moisture.
•
For the most efficient refrigeration, be sure to provide good air
circulation inside and out.
•
Inside refrigerated cabinet: Do not pack unit so full that air cannot
circulate. Take care not to block air flow to the fans and allow
space along the sides.
•
Outside refrigerated cabinet: Be sure the unit has access to ample
air; avoid hot corners and locations near stoves and ovens. It is
suggested the rear of the unit be no less than two inches from
any wall, partition or any other object which will restrict exhaust
air flow.
•
Lift units by ribs at designated places. Stickers provided. See
Photos 1 and 2.
2. Study lineup, floor plan and utility connections to determine order of
installation. Place Unit #1.
3. Remove the galvanized shipping braces from the bottom of the unit.
4. Screw adjustable feet all the way in on the first unit. Level to work
height, usually 36” or as specified.
5. Level Unit #1 front to back and left to right by adjusting the bullet feet.
6. Use caution when placing units together to protect against damaging
the laminate.
7. Place Unit #2.
8. There are (approximately 3) holes along the top and bottom sides.
Thread a 1/4-20 x 1” bolt through the unit 1 bracing hole, two supplied
washers and unit 2 bracing hole. Secure with a nut. Repeat for each
hole. Do not tighten until Unit #2 is level.
9. Level Unit #2 front to back and left to right by adjusting the bullet feet.
10. Tighten the nuts and bolts that connect Unit #1 and #2.
11. Repeat steps 6-10 as you add each additional unit.
11. Connect the electrical quick connects in the bases.
12. Have the top installed. Verify it is secure and level.
Photo 3. First view of units placed
next to each other
Photo 1. The units should be lifted
by the bracing only
Photo 2. DO NOT lift the units by
anything but the bracing
