DELEX DSI ES8300, Installation And Operation Instructions Manual

Page: 37 / 39

37
DESIGNED SECURITY INC 800-272-3555 www.dsigo.com
1402 Hawthorne Street Bastrop, Texas 78602 Fax 512 321 9181
Email: dsi@dsigo.com
INS8300
Congratulations on your purchase of a DSI Optical Turnstile system.
This guide provides information for cleaning and maintaining the finishes, materials and optical paths of DSI’s standard
finishes on our turnstile line. Including ES810, ES811, ES831, ES880, ES8300, ES840, ES850, and ES860
DSI recommends the following information be distributed to appropriate personnel to preserve long lasting appearance of
the finish, and to maintain clear optical paths for the Infrared beams.
Stainless Steel -
CAUTION: Avoid getting polish or solvents on the Plexiglas panels to prevent
contaminating the optical path.
The suggested polish is a light household polish/oil.
Holloway House Lemon Oil is what we use at the factory.
http://www.hollowayhouse.net
Soap and water may be used to clean stains, then use polish to preserve the finish.
Corian and Laminates-
Soapy water or ammonia-based cleaners will remove most dirt and stains from Corian and Laminate finishes.
Additional Corian information is available from the DuPont Corian website:
http://www.corian.com
Brass -
These finishes are clear-coated and should be polished with any product labeled as appropriate for a clear-coat
finish. Automotive clear-coat polishes work well for this application. (Turtle Wax’s Clear Coat Polish and Restorer
is what we use at the factory)
Powder Coat Painted -
Clean with mild soap, water and a soft non-abrasive cloth. A periodic use of a non-ammonia based cleaning
solution (Formula 409) can be used for oils or stubborn stains. Always apply by hand using a circular motion.
Plexiglas -
CAUTION: Never use ammonia-based glass cleaners, abrasive cleaners, or paper towels to clean
Plexiglas.
These surfaces should be cleaned with a soft cloth dampened with soap and water, or use a spray cleaner such as
Chemtronics® ES1668; at
http://www.chemtronics.com/
or you may call Chemtronics at 800-645-5244
for more information.
Optics -
The Plexiglas over the sensors and reflectors must be kept optically clear for the Infrared Beams to
function properly. Cleaning personnel need to be instructed to avoid wiping any oils or other polishes on these
panels. Use of alcohol or ammonia based cleaners may leave a static charge which will attract dust, the
Chemtronics® ES1668 is an anti-static cleaner that works well. Any similar anti-static cleaner approved for use on
Plexiglas should work.
Dust accumulation on the inside of these Plexiglas panels, and on the Sensors/Reflectors themselves, can impair
the optical path which may lead to false alarms. A periodic inspection after initial installation may help determine
the appropriate interval for cleaning the inside surfaces, based upon the environment at the site.
CARE AND CLEANING