9
iom 1900 / 2400 dual hose reel manual
P/n 962101 2008.10.24 rev. 2
2.0 Installation
2.5 ratchet
2.5.1 The ratchet option allows the extended hose to be pulled out and held from retraction by spring tension; generally appropriate for operator
attended applications.
2.5.2 The ratchet for the 1900 & 2400 Series Hose Reels is spring loaded. It is designed to function in all acceptable mounting configurations.
2.5.3 The ratchet option can be installed at the time of purchased or later added to reels that have already been introduced to service.
2.5.4 ratchet option installation
2.5.4.1
WarninG:
Fluid Pressure should be disconnected from the reel before beginning any service or maintenance functions. Follow lock-
out/ tag-out procedures appropriate to the facility.
2.5.4.2 ratchet Pawl installation
2.5.4.2.1 The ratchet pawl assembly is attached to the reel frame as
a unit. The holes provided for the attachment of the ratchet
pawl assembly are located in the lower middle of the frame.
2.5.4.2.2 Insert the (2) 3/8 -16x1” bolts (provided) in the frame.
2.5.4.2.3 Position the ratchet pawl assembly over the protruding bolt
shafts.
2.5.4.2.4 Secure using the (2) sets of 3/8-16 hex nuts & lockwashers
provided.
2.5.4.3 ratchet Plate installation
2.5.4.3.1 Loosen the (2) 1/4-20 setscrews on the spool hub with a
1/8” allen wrench and adjust spool so that the ratchet pawl
pin clears the spool by 0.030” to 0.125”.
2.5.4.3.2 Locate the four (4) bolt holes in the inside spool flange for
the ratchet teeth. These will be arranged in two sets of
two, 180 degrees from each other.
2.5.4.3.3 Mount the ratchet teeth in one of these sets of holes
oriented as in the figure below. Be sure to install the
provided bolts from inside the spool so that the nuts are on
the outside of the spool and will not rub on the hose.
2.5.4.3.4 A second set of ratchet teeth can be added to the second
set of holes if desired to provide more frequent locking
positions.
