17
3.
M
OWERS GREASING
All the greasing points, both those situated and both centralized, are equipped with greaser HYDRAULIC
TYPE MODEL “A” UNI 7663.
To grease use only MULTIFUNCTIONAL GREASE LITHIUM BASED Type NLGI 2.
Refer to diagram, greasing points are points "C" one per each wheel, point "D" located on a bracket in front
of gear box bracket.
Greasing operation must be made at the terms scheduled on diagram “A”.
4.
M
OWERS OIL CECK – OIL SUSTITUTION
To fill and to change oil use only OIL SAE 90 EP, oil capacity of angolar gear box is 0,5 L.
Oil fill and oil change operations must be made at the terms scheduled on diagram “A”.
a) To check oil level in angular gear box operate as follows :
1. With the cutting machine on level, unscrew level plug "A", then check that oil touchs on lower hole
rim.
2. If level it's ok screw the plug "A".
3. If level it's low unscrew plug "B" and fill oil.
4. When level it's ok screw plugs "A" and "B".
b) To change oil in angular gear box operate as follows :
1. Unscrew plugs "A", "B".
2. Take away oil through hole "B" using a suitable little pump.
3. Put new oil through plug "B".
4. When level it's ok screw plugs "A" e "B".