10
1.
M
AIN FRAME "1"ASSEMBLING
a) Insert
the
REAR HUB "2"
in the fitting fork found in the rear right side from the
MAIN FRAME "1"
,
adjust it the height on
POSITION 1
if the cutting components are equipped with rubber wheels, or in
POSITION 2
if the cutting components are equipped with pneumatic tires (see
TABLE "A"
on reference
scheme), insert the screws and lock them with nuts.
b) Insert
the
REAR WHEEL "3"
in the hub, fix it with the special nut.
c) Repeat steps "
a
" and "
b
" on the rear left side of the
MAIN FRAME
.
d) Insert
the
LIFTING JACK "4"
in the seat found in the front of the
MAIN FRAME
, insert the screw and
lock it with the nut.
e) Insert
the
RIGHT SIDE CONNECTION FRAME "5"
in the special forks found on the right side of the
MAIN FRAME
orienting it with the hitch fork hydraulic ram oriented to the top, insert the pins and lock
them with the nuts.
f) Insert the hitch welded at the bottom of the
HYDRAULIC RAM "18"
in the special fork found on the right
side of the
MAIN FRAME
. Insert the pin but not screw the fixing nut.
g)
Repeat steps "
e
" and "
f
" on the left side of the
MAIN FR
AME utilizing the
LEFT SIDE CONNECTION
FRAME "6".
h) Insert
the
FRONT SIDE SAFETY DEVICE "19"
on the fixing pins of the hydraulic rams orienting them
with the guides side end stroke rod oriented to the front of the frame, lock it utilizing the nuts described
in the step "
f
".
i) Insert the hitch screwed to the hydraulic ram stem in the special fork found on the right connection
frame, insert the pin and lock it with the safety clips. Extend the ram until carry the frame in horizontal
position.
j)
Repeat step "
i
" on the left side of the
MAIN FRAME
.
k) Insert
the
REAR CONNECTION FRAME "16"
in his special forks found in the rear side of the main
frame orienting it with the hitch fork hydraulic ram oriented to the up, insert the pins and lock them with
the nuts.
l) Insert the hitch welded on the bottom of the
HYDRAULIC RAM "18"
in his special fork found on the left
rear side of the main frame. Insert the pin but don't lock the fixing nut.
m) Insert the
REAR SAFETY DEVICE "20"
on the fixing pin of the hydraulic ram orienting it with the fixing
bracket oriented to the low, lock it utilizing the nut described in the step "
l
" and the locking screw of the
bracket.
n) Insert the hitch locked to the hydraulic ram stem in his special fork found on the rear connection frame,
insert the pin and lock it with the safety clips. Extend the ram until carry the frame in horizontal position.
o) Connect the unhooking cable to the rear safety device through the special spring-clip.
p) Remove from the connector situated in the right top side of the hydraulic ram the protection cap, lock the
terminal connector of the
SIDE HYDRAULIC PIPE "27"
to the ram connector.
q) Repeat step "
p
" on the left of the machine.
r) Remove the protection cap from the connector situated in the up side of the hydraulic ram, lock the
terminal connector of the
REAR HYDRAULIC PIPE "28"
to the ram connector.
