7
DEHOUST GMBH – GUTENBERGSTR. 5-7 – D-69181 LEIMEN – www.dehoust.com
3.6.
Unauthorised use
The
break tank system
is not intended for use outdoors. Temperature, light and humidity influences can result in malfunctions
and damage to the device.
Do not use the
break tank system
outdoors.
Only use the
break tank system
for its intended purpose.
Do not fill the media connections of the system with aggressive or flammable media.
Do not apply mechanical loads to the housing (e.g. by using it to store objects or a step).
Do not make external changes to the device housings. Do not paint housing parts and screws!
Do not disassemble the
break tank system
beyond the degree needed for installation and service.
4. Transport
The product must not be connected to the electrical feed line during transport. During transport, it is important to protect the device
from being knocked and dropped. The product must be stored in a dry, cool and sun-protected, as well as frost-proof room.
Each packaging unit must be checked for damage at goods transfer. In case of transport damage, determine and document the
exact damage and immediately report to DEHOUST in writing.
5.
Assembly
5.1.
Assembly
area
The
break tank system
must be set up in a frost-proof, dry and well ventilated room on ground level and on a level surface. The
load-bearing capacity must be equal at a minimum to the total weight of the
break tank system
in filled operating condition (see
3.2). The room temperature must not exceed the maximum permissible temperature (see
3.2) to minimise hygienic risks in the process water storage tank.
Do not operate the
break tank system
near living rooms or bedrooms due to the noises caused by feed units and
pumps.
Observe the space requirements for operation and repairs.
A suitable sound insulation panel can be used to create the sound decoupler between the storage tank of
the
break tank system
and the building.
The installation room must have a suitable floor drain/sump to securely drain away the overflowing water in case
of backflooding over the emergency overflow vent of the process water storage tank.
5.2.
Immersion pressure pump in the storage tank
The immersion pressure pump comes already installed in the storage tank and bolted to the pressure connection of the immersion
pressure pump and at the top middle tank lid with HDPE pressure pipe and a quick connector. The power cable is threaded through
the tank lid with steel conduit threading.
