Degometal GO 182, Manual

Page: 22 / 32

22
www.degometal.com
DAILY
• Daily, before use or when first putting the tool into service, pour a few drops of clean, light
lubricating oil into the air inlet of the tool if no lubricator is fitted on air supply. If the tool is
in continuous use, the air hose should be disconnected from the main air supply and the
tool lubricated every two to three hours.
• Check for air leaks. If dama ged, hoses and couplings should be replaced.
• If there is no filter on the pressure regulator, bleed the air line to clear it of accumulated
dirt or water before connecting the air hose to the tool. If there is a filter, drain it.
• Check that the nose assembly or swivel head is correct for the fastener to be placed.
• Check the stroke of the tool meets the minimum specification (page 19). The last step of
the Priming Procedure explains how to measure the stroke.
• Either a stem collector or a stem deflector must be fitted to the tool unless a swivel head
is fitted.
• Check that Base Cover 36 is fully tightened onto body 34 .
• Ensure that rotary valve 60 is correctly adjusted for fastener retention(see Operating
Procedure page 6).
WEEKLY
• Dismantle and clean the nose assembly with special attention to the jaws. Lubricate with
Maly Lithium grease before assembling.
• Check for oil leaks and air leaks in the air supply hose and fittings.
MOLY LITHIUM GREASE EP 3735 SAFETY DATA
Grease can be ordered as a single item, the part number is shown in the service kit page 10.
First Aid
SKIN:
As the grease is completely water resistant it is best removed with an approved emulsifying
skin cleaner.
INGESTION:
Contact the emergency services
EYES:
Irritant but not harmful. Irrigate with water and seek medical attention.
Fire
FLASH POINT: Above 220°C.
Not classified as flammable.
Suitable extinguishing media: CO2, Halon or water spray if applied by an experienced operator
.
Environment
Scrape up for burning or disposal on approved site.
Handling
Use barrier cream or oil resistant gloves
Storage
Away from heat and oxidising agent.
Item numbers in
bold refer to the general assembly drawing and parts Iist.