Degometal GO 182, Manual

Page: 19 / 32

19
www.degometal.com
others in the vicinity to protect against fastener ejection, should a fastener be placed 'in air' .
We recommend wearing gloves if there are sharp edges or corners on the application.
17
Take care to avoid entanglement of loose clothes , ties , long hair , cleaning rags etc. in the
moving parts of the tool which should be kept dry and clean for best possible grip .
18 When carrying the tool from place to place keep hands a w ay from the trigger/lever to avoid
inadvertent start up.
19 Excessive contact with hydraulic fluid oil should be avoided . To minimize the possibility
of rashes, care should be taken to wash thoroughly .
3. PREPARATION
AIR SUPPLY
All tools are operated with compressed air at an optimum pressure of 5 . 5 bar . We recommend
the use of pressure regulators and automatic oiling/filtering systems on the main air supply .
These should be fitted within 3 metres of the tool (see diagram below) to ensure
maximum tool life and minimum tool maintenance
.
The air supply pipes used must have a suitable pressure resistance. Air hoses should be oil
resistant, have an abrasion resistant exterior and should be armoured where operating conditions
may result in hoses being damaged. All air hoses MUST have a minimum bore diameter of 6.4
millimetres or
1/
4 inch .
Read servicing daily details.