Assembly Instruction
DEGERtraker
Part IV
– Module carry system
DEGERtraker 9000NT
Assembly Instruction DEGER
traker
3000NT / 3000HD / 5000NT / 5000HD / 6000NT / 7000NT / 9000NT
2012-07-01
Page IV-5
Module arrangement:
The following dimensions have to be abode and have to be reduced according to regional conditions if
necessary:
- Module surface:
max. 70m²
- length of Module surface:
max. 11.80m
- height of Module surface:
max. 6.00m
The total module area is to be determined relative to the site with the aid of the DEGERenergie
dimensioning tool and may in no case be greater than 70m².
1st step: Arrangement of aluminium profiles:
Distance between 2 aluminium profiles:
x
= width of module / 2
(
attend the point of fastening from the modul manufacturer
)
Overhang of the aluminium profile
:
y
= (length of aluminium profile - 2.60m) / 2
Following points have to be attended:
- assemble aluminium profile from the middle to the outsite
- in both axis modules have to be arranged symmetrically to the center of gravity.
Recommendation: Move
the modulesurface 3 cm towards the top to reduce the self consumption of the system and to exeed
the lifetime durability of the system.
- 2 aluminium profiles for each row of modules
- attend the connecting socket on the backside of the modules
2nd step: Assembly of aluminium profiles
see Page IV-6!
In the range of the suspension
for the elevation motor it is not
possible to assemble the
MTH-clamps at the outside of
the base frame. Here the
MTH-clamps have to be
assembled at the inside of the
base frame.
Please pay attention to notes
in step 2!
y
+
3
c
m
y
-
3
c
m
