PRO-CTR-MAN-16V03 (0128)
Copyright © 2016 Defi ne Instruments
24
E
_ _ _ USER INPUT 3
scrolls across the display, and the current function appears.
This specifi es the operation to be executed when the User 3 pin is activated
from the rear of the unit (see 3.6). Referring to the table above, use the
and
buttons to select a function, and then press
.
8.6 - Analog output setup
A
_ _ _ ANALOG OUTPUT SETUP
scrolls across the display, and
SKIP
appears. If
your controller does not have analog output installed, (or you do not wish to
confi gure your analog output now), press
to skip to 8.7.
Otherwise, press the
button and then
to
ENTER
analog output setup.
B
_ _ _ DATA SOURCE FOR ANALOG OUTPUT
scrolls across the display, and
the current analog output data source appears. Use the
and
buttons
to select an option from:
NONE
,
PRMCTR
,
B CNTR
,
C CNTR
,
RATE
,
BATCH
or
BCHCNT
, and then press
.
C
_ _ _ LOW SCALE VALUE FOR ANALOG OUTPUT
scrolls across the display, and
the currently selected low scale value appears. Use the
and
buttons to
enter your cal low position, and then press
.
This sets the display value for
CAL LOW
(as in 8.6F, below).
D
_ _ _ HIGH SCALE VALUE FOR ANALOG OUTPUT
scrolls across the display, and
the currently selected high scale value appears. Use the
and
buttons to
enter your cal high position, and then press
.
This sets the display value for
CAL HIGH
(as in 8.6G, below).
E
_ _ _ CALIBRATE ANALOG OUTPUT?
scrolls across the display, and
SKIP
ap-
pears. To skip analog output calibration, press
now and go to 8.7.
To calibrate your analog output now, connect a mA or volt meter across the
analog output connector (see 3.4). Then press the
button, followed by
,
to
ENTER
analog output calibration mode.
F
_ _ _ CAL LOW ANALOG OUTPUT
scrolls across the display. A calibration num-
ber displayed in internal units (mA/V) appears. Using the
and
buttons,
calibrate your low analog output as required, and press
.
