7
HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Installation (continued)
4
Installing the mounting plate
Ƒ
Route the junction box wires through the hole
in the mounting plate (D).
Ƒ
Place the mounting plate (D) against the
junction box.
Ƒ
When mounting to a wall, the “UP” arrow
must point upward.
Ƒ
When mounting to an eave, the “UP” arrow
must point toward the building.
Ƒ
Insert the large mounting bolt (DD) through
the mounting plate (D) hole located below the
threaded hole, and thread it into the center
hole of the mounting bracket (FF). Tighten the
bolt (DD) securely.
Ƒ
Firmly pull on the mounting plate (D) to
verify it is securely attached to the mounting
bracket (FF).
FR
ONT
N (Wh
ite/
Bla
nc/Blan
co)
GND
Terre
Tierra
UP/Hau
t/Ar
riba
L (Black
/
No
ir/N
egro
)
UP/Haut/Ar
riba
5
Making the electrical
connections
Ƒ
Insert the junction box wires into the side of
the terminal block and around the ground
screw. Tighten terminal block screws using
the mini-screwdriver (GG) and ground screw to
secure the wires.
Ƒ
Insert the white wire from the junction box
into the terminal marked “N (White)”.
Ƒ
Insert the black wire from the junction box
into the terminal marked “L (Black)”.
Ƒ
Connect the bare or green ground wire
from the junction box to the ground screw
(marked with “GND”).
N (White/
Blanc/Blanco)
GND
Terre
Tierra
UP/Haut/Arriba
L (Black/
Noir/Negro)
6
Mounting the light fixture
NOTICE:
The two pins on the rear of the light fixture must be
inserted into the terminal block for the light to work.
Ƒ
Align the bottom edge of the light fixture (B) with
the bottom edge of the mounting plate (D). Tilt
the light fixture (B) toward the mounting plate (D),
making sure the light fixture (B) is centered on
the mounting plate (D).
Ƒ
Tighten the small mounting bolt (EE) securely
through the center of the mounting plate (D). Do
not overtighten.
Ƒ
Push the rubber plug (AA) firmly into the
mounting bolt hole on the light fixture (B).
EE
AA
D
B
D
D
DD
FF
