Defi ADVANCE ZD, Operation Manual

Page: 82 / 112

8 -5.・Opening・mode,・Ending・mode
When the ignition is turned on, ZD performs opening mode. When the igni-
tion is turned off, ZD performs ending mode and then the power supplies to
the unit and ZD are shut off.
Confirmation
Depending on vehicles, the ignition is not turned off immediately after the
key is turned off. In this case, ending mode doesn’t start until the ignition is
turned off.
■ Change・of・Opening・mode/Ending・mode
Opening and ending modes can be selected from A and B types by sliding
the dip switch 2 on the ADVANCE Control unit. (If gauges are connected the
ADVANCE system, the opening/ending modes for gauges are also changed.)
Change the type when the ignition is off.
Both types consist of digital displays and lighting of sequential indicators. Try
both types!
8 -6.・Operation・mode
Warning
In order to ensure safe driving, check the information on the gauge only for
a short period of time. Looking at the display for a long period of time could
distract attention from the road and result in an accident.
Do not operate while driving.
8 -6-1.Brightness・adjustment
CU・OPR
(slide switch position：
U
)
The brightness can be adjusted by pressing
R
button in real
mode and record mode. AUTO and MANUAL can be selected in the setting of
dimmer control in system setup mode.
⇒8 -2-5. Refer to Dimmer setting [DIMMER]
AUTO ：3 automatic levels and constant maximum brightness level
(AUTO is not interlocked with vehicle dimmer switch on/off.)
MANUAL ： 5 constant levels each in daytime and nighttime being interlocked with ve-
81