Defi ADVANCE ZD, Operation Manual

Page: 100 / 112

Warning
If any indication of the problem is found in the product, check to make sure
the product will operate as expected. Failure to do so can lead to serious ac-
cidents.
If any problem is found during using, setting or operating this product, use
the following table to confirm proper operation of the unit. If the operational
problem is not found in the following table, contact the installation personnel
at the store where this product was purchased.
9 Troubleshooting
Condition Possible Cause Corrective Action
○ Does not oper-
ate.
○ Power is not
supplied.
○ DC Source
LED of the unit
doesn't light.
○ Wiring of the power supply
wire is improper.
○ The fuse of the power sup-
ply wire is blown out.
○ The locks of the solderless
connectors are not locked
tightly.
○ Check wiring of +B, IGN, GND as per
instructions in this manual.
○ Check wiring and replace the fuse.
○ Check the lock of the solderless con-
nectors.
○ DC Source LED
of the unit is
blinking.
○ There is a wire short
circuit or disconnected wire
somewhere. Maybe there
is something wrong on
gauge.
○ Please reconfirm the wiring and
the gauge according to operation
manual. If any defects are not found,
please ask the shop for inspection.
○ Does not carry
out the ending
mode.
○ The battery wiring is im-
proper.
○ Check wiring of +B as per instruc-
tions in this manual.
○ Check the solderless connector of
battery wiring.
○ Please ask the store for inspection.
○ The illumination
of gauge does
not turn on.
○ The ILM wiring is improper.
○ The locks of the solderless
connectors are not locked
tightly.
○ The brightness level is set at
MANUAL LEVEL:0.
○ The dimmer setting is AUTO
and the outside is bright.
○ Check wiring of ILM as per instruc-
tions in this manual.
○ Check the lock of the solderless con-
nectors.
○ Release illumination cancel function
as per instructions in this manual.
○ Change the dimmer setting.
99