Specification
Page 15 of 36
057-300 ISSUE: 1.1
.
2.9.3 WEIGHT
<1 kg
(<35.3 oz)
2.9.4 FIXING
NOTE: In conditions of excessive vibration, mount the housing on suitable anti-vibration
mountings.
The device is held into the panel fascia using the large nut provided.
•
Place the controller into the panel aperture.
•
Attached the supplied fixing nut and hand tighten to provide adequate fixing (see below).
•
Attach the connector plug (Plug A) and push home to click into place.
2.9.4.1
TORQUE SETTING OF FIXING NUT
8 Nm
5.9 ft-lb
2.10 APPLICABLE STANDARDS
Standard
Description
BS 4884-1
This document conforms to BS4884-1 1992 Specification for presentation
of essential information.
BS 4884-2
This document conforms to BS4884-2 1993 Guide to content
BS 4884-3
This document conforms to BS4884-3 1993 Guide to presentation
BS EN 60068-2-1
(Minimum
temperature)
-40
C (-40
F)
BS EN 60068-2-2
(Maximum
temperature)
+85
C (185
F)
BS EN 61010
Safety requirements for electrical equipment for measurement, control,
and laboratory use
BS EN 61000-6-2
EMC Generic Immunity Standard (Industrial)
BS EN 61000-6-4
EMC Generic Emission Standard (Industrial)
BS EN 60529
(Degrees of
protection provided
by enclosures)
IP67 front and rear
In line with our policy of continual development, Deep Sea Electronics, reserve the right to change
specification without notice.
